If you’re looking for a quick and easy plug-in solution to go with your Elite ECU then Plug’n’Play Adaptors are your best option.
Plug’n’Play Adaptor Harness allows you to use Haltech’s universal Elite ECUs by connecting them directly to the factory harness in your car via a Plug’n’Play Adaptor. This is an ideal solution for builders and tuners who want a quick and easy install without the need to rewire.
The Plug’n’Play Adaptor Harness comes complete with an adaptor box which has the factory ECU connector on one side and the Haltech mating connectors on the other.
The Adaptor Harness connects the adaptor box to an Elite ECU on one side and to your car’s factory ECU harness on the other.
With the Haltech ECU connected, launch the Elite Software Programmer (ESP) and load your base map from the Haltech base map library. The base map will be sufficient to get your car going and give you a great starting point for further tuning.
Honda S2000 AP1 (00-04), Honda S2000 AP2 (05)
Non DBW, manual transmission only.
Supported Engines: F20C
Supported OEM Functionality:
• Idle Control (BAC)
• A/C Request And Control
• Engine Control Relay
• Fuel Pump
• Electrical Power Steering Load Detect
• Knock Sensor 1
• Coolant Temperature Sensor
• Air Temperature Sensor
• O2 Sensor Front & Rear
• Check Engine Light
• Throttle Position Sensor
• Vehicle Speed Sensor
• VTEC Oil Pressure Switch
• VTEC Solenoid
• Air Pump Relay*
• Factory Map Sensor
• Alternator Control
• Alternator FR Signal
• Brake Pedal Switch
• Electrical Load Detect
• Evap Canister Purge*
• EVAP Canister Vent Shut*
• EVAP Bypass Solenoid*
• Vacuum Control Solenoid*
• S2000 Coolant Gauge (PWM Out)
*NOTE: OEM Functionality is improved when moving up from Elite 1000 to Elite 2500. See the table below:
OEM FUnctionality Not Supported :
• Immobiliser Indicator Light
• Immobiliser Code
• Fuel Tank Pressure Sensor
• K-line Communications
• Start Switch Signal
• Air Pump Electric Current Sensor
Elite 1000 + Plug’n’Play Adaptor Harness Kit for Honda S2000
Part Number: HT-150843
Kit Includes: Elite 1000 ECU, Plug’n’Play adaptor harness, M14 x 1.5 air temp sensor with matching plug and pins, auxiliary I/O 16 Pin TYCO plug and pins, USB programming cable and USB software key.
Elite 1500 + Plug’n’Play Adaptor Harness Kit for Honda S2000
Part Number: HT-150962
Kit Includes: Elite 1500 ECU, Plug’n’Play adaptor harness, M14 x 1.5 air temp sensor with matching plug and pins, auxiliary I/O 16 Pin TYCO plug and pins, USB programming cable and USB software key.
Platinum PRO Plug-in ECU for Honda S2000
Part Number: HT-055050
Kit Includes: Platinum PRO Direct Plug-in ECU, Plug and pins for auxiliary I/O harness. Haltech CAN adaptor cable DTM-4 female receptacle/socket to 8 pin black Tyco 3″/75mm (used to adapt a Platinum series ECU to a DTM-4 Elite CAN system), USB programming cable and USB Software Key.
Note: Requires a CAN I/O12 Expander Box to accept an input from a flex fuel sensor.